-
Anonymous users2024-01-24The working principle of the water tank: the water level in the water tank is controlled by the float to control the switch of the water supply, that is, the float stops the water as the water level in the tank rises, and the water enters when it falls; When someone flushes the water, press the button --- pull out the rubber plug at the bottom of the water tank, the water in the water tank is flushed out immediately, and the rubber plug is finally flushed back to the drain at the bottom of the water tank by the water at the bottom of the water tank, blocking the drain, and the make-up water also enters the water to the high water level at the same time, and works again and again.
-
Anonymous users2024-01-23First of all, open the upper cover of the water tank: then you will see a float, the float has a connecting rod connected to the water inlet, if the water storage of the tank needs to increase, please lift the float up and adjust it to the appropriate position, so that the required amount of water can be increased! On the contrary, if the water storage capacity of the tank is too large, then adjust the float down to the appropriate position!
The basic structure of the common water tank is like this! You try it, it's not very complicated!
-
Anonymous users2024-01-22The structure of the tank is different, but you can try removing the lid of the tank and cleaning the limescale on the parts inside, which should work.
See if the filter is clogged.
Solution: Close the valve on the hose connecting to the water inlet of the tank. Flush the toilet again and drain the remaining water from the tank. >>>More
If the middle of the tank lid is a button switch, use a tool to clamp the outside of the button switch, turn counterclockwise, remove the button, the tank lid can be opened, and if the tank lid can be lifted.
Try turning off the tap water, draining the water, letting the air in, and then turning on the tap water.
The principle of automatic flushing of toilets:
There is a float valve inside, as the water level in the tank rises, the buoyancy generated by the float increases, and when the water level rises to a predetermined value, the buoyancy generated by the float will be transmitted to the plug that discharges the water through a seesaw structure, and the plug can be automatically pulled up as long as the drain button is pressed. After the water is discharged, the plug automatically returns to its position under the action of the spring and enters the next round of water filling cycle. >>>More
Toilet flush valve is a common one in our family, but how to install, the flush valve used in the toilet in different places is different, now there are three kinds of toilet flush valves, induction, foot pedal, manual, and one is a toilet flush that uses a water tank, and the principle of their flush valve is different. So how to repair the toilet flush valve keeps coming out of the water? >>>More