What should I do if there is a large amount of water leakage at the interface between the plastic ho

1. In addition to the sealing rubber ring with the drain leakage belt, it is necessary to play some porcelain white glue (or glass glue) around the rubber ring to strengthen the sealing. 2. Seal between the drain and the drain hose, the drain hose may be slightly thicker than the drain joint, and some raw material tape can be wrapped between them to strengthen the seal. It can also be wound and reinforced with some iron wire in the outer ring.

3. Between the sewer hose and the ground sewer pipe, there is usually no need to take the form of special sealing liquid, if in order to prevent odor and insects, you can wrap transparent tape at the interface between the hose and the ground wheel celery pipe to seal.

There are several ways to seal sewer lines:

1. In addition to the sealing rubber ring with the drain leakage belt, it is necessary to play some porcelain white glue (or glass glue) around the rubber ring to strengthen the sealing.

2 Seal between the drain and the drain hose, some drain hoses may be slightly thicker than the drain joint, you can wrap some raw meal tape between them to strengthen the seal. It can also be wound and reinforced with some iron wire in the outer ring.

3. Between the sewer hose and the ground sewer pipe, there is usually no need to take a special sealing form, if in order to prevent odor and insects, you can wrap transparent tape at the interface between the hose and the ground pipe to seal.

Start by identifying where the water is leaking. If it is only a joint leakage, under the premise that the quality of the pipe is qualified, the joint can be replaced or a leak-proof sealing tape and AB sealant can be added to the joint; If the quality of the pipe is not good, the pipe should be replaced. You can also apply the adjusted AB glue in the leaking place, and then wrap a layer of ribbon on it, so that the ribbon is soaked with AB glue and then apply a layer of AB glue on the ribbon, and the whole process can be divided into two or many times.

Hope it helps, I wish you a happy life, thank you.

Check your own sewer pipes.

1. In addition to the sealing rubber ring with the drain leakage belt, it is necessary to play some porcelain white glue (or glass glue) around the rubber ring to strengthen the sealing.

2 Seal between the drain and the drain hose, some drain hoses may be slightly thicker than the drain joint, you can wrap some raw meal tape between them to strengthen the seal. It can also be wound and reinforced with some iron wire in the outer ring.

3. Between the sewer hose and the ground sewer pipe, there is usually no need to take a special sealing form, if in order to prevent odor and insects, you can wrap transparent tape at the interface between the hose and the ground pipe to seal.

Try to reinforce it with raw material tape and waterproof tape, if the quality of the sewer pipe is poor, change it to a sewer pipe, if not, it is a problem at the interface, find someone to do the waterproofing.

Just change to a longer plastic hose and insert it deeper.

There is a possibility that the drain pipe is blocked, there is something in it, causing poor drainage, see if it can be dredged, if it is not blocked, make a U-shaped diving bend of the drainage hose, reduce the flow and flow rate of the drainage, let the water flow flow out at a uniform speed, as for the interface, it can be sealed with glass glue!