-
Anonymous users2024-01-24Kitchen lights and bedroom lights should be connected in parallel. Judging from the situation you described, there should be a problem with the wiring, so check it carefully.
Is there a wrong wiring, the high-current equipment is turned on, causing the lighting line to be overloaded, and whether the heater is connected to the lighting line?
There are many such cases.
For example, table lamps and floor lamps are not all plugged into sockets. Because the light path does not need to be leaked (only zero live wire), and the socket is a zero three wires of fire ground, as long as your socket is connected to the leakage protection, the two conditions of use are fully met, so the light path can be the same circuit as the socket, but the socket can not be connected to the pure light path (no ground wire). >>>More
This is possible. However, it is not necessary to use the same circuit, nor is it mandatory to use different circuits.
There is a seven-hole plug with a switch, and the socket in the general bathroom is only used to charge the shaver. But if you use a hair dryer, you still need to use a separate socket, because the hair dryer is generally more than 1000 watts.
1. See where it's missing.
2. If the water inlet leaks, buy a roll of raw meal tape. First of all, turn off the main switch, twist the pipe of the water inlet with a wrench, wrap it counterclockwise with a raw tape on the thread of the pipe (multi-wind), and twist the pipe back. Ok >>>More