-
Anonymous users2024-01-24If you have the ability, remove it and check if the motor is stuck, or if the impeller is stuck. I won't get it myself, so I will remove it and send it to the shop that repairs the motor for repair.
How to install a booster pump? I never thought that it would be horizontal or vertical, and the correct installation method is like this.
It should be that the pipe is blocked, so that the water pressure and water flow are reduced, and the water can be used when the water is adjusted to the highest level.
1: Water flow automatic booster pump.
Working principle: through the flow rate (4L per minute) in the water pipe to push the water flu response device (water flow switch) in the water pump, the sensor conducts the signal to the controller in the water pump, the controller controls the pump motor to work, and the pump works to pressurize the water supply. >>>More
The booster pump has a flow switch, if it is connected to the back of your water meter, then, wherever you use water in your home, the booster pump will start to work and pressurize because of the flow of water. If you only want the bathroom and kitchen to have a pressurization effect, then cut off the water pipes before entering the bathroom and kitchen, and then connect the booster pump.
The booster pump pumped water to increase the pressure of the pipeline, and the faucet seal was damaged, and the pressure could not be sealed.