What should I do if the waterproof brush falls off the wall of the toilet?

Updated on Toilets 2024-05-09
2 answers
  1. Anonymous users2024-01-23

    Scrape off all the walls and repaint them, or they won't be useless.

  2. Anonymous users2024-01-22

    If the wall is damp, it is normal for the local climate to be humid or the back of the damp wall is damp, and the wall is damp due to water seepage from the back.

    1. Thoroughly clean the peeled and damp wall with a shovel.

    2. Continue to remove the floating ash on the wall to prevent the floating ash from affecting the bonding strength.

    3. Evenly brush the separator with a brush and apply it 2-3 times, with an interval of about 3 hours between each time.

    4. After the isolator is dried, the putty can be scraped in batches, and the batch scraping time is not less than 24 hours each time.

    5. After the putty is dried, carefully polish it with No. 180 sandpaper.

    6. Clean the surface dust and paint latex paint 2-3 times, with an interval of about 6 hours between each time.

Related questions
4 answers2024-05-09

Although the developer has done waterproofing before, when the water and electricity renovation is carried out, the waterproof layer of the bathroom has basically been destroyed, so it is recommended that all waterproofing needs to be redone. >>>More

5 answers2024-05-09

Safe and environmentally friendly waterproof materials are preferred. The traditional waterproof material requires the moisture content of the construction base surface to be less than 9%, and the kitchen and bathroom are relatively wet, and it is difficult for the building to reach the requirement of dropping the base surface, and it is very easy to appear after the construction of the waterproof layer and the base surface to separate the "two skins" phenomenon, thereby losing the waterproof effect. It is recommended to use mortar waterproofing agents. >>>More

1 answers2024-05-09

The bricklayer's statement is correct, the cement is the tile adhesive and cement mixed with two materials, to prevent the tile from hollowing off the brick, and enhance the adhesion between the tile and the cement wall. There are two kinds of tile adhesive, one is the powder state, the other is the emulsion state, many owners for the sake of convenience, choose the tile adhesive more. >>>More

1 answers2024-05-09

Is there a lot of area, and it is normal for individual empty ones.

9 answers2024-05-09

Of course, it is necessary, of course, the bathroom needs to be directly waterproofed construction engineering, after all, the bathroom is the place with the most domestic water. Waterproofing is the most important protection project, in the decoration is the most important thing, especially like the bathroom this special place, it is necessary to do a good job of waterproofing, you want to take a bath every day, if the waterproof work is not in place, it will leak, when the repair is particularly troublesome. >>>More