How do you mix the color of furniture?

Color fine color mixing, the proportion is very small, there should not be much harm, because it is cheap to achieve the effect, of course, if you have doubts, you can use paint, but the waste is too big, the cost is higher.

The transparent is the color essence, and the opaque is leaked with the color potato.

The color is matched on the white tile first, and only the color density of the occlusion paper is pulled.

When mixing colors, grasp the proportions first, and then add a little resin.

I've been grading like this before:

First use a cup to weigh 100 grams of 84 to be colored, and then weigh the total weight of the color essence to be used in the color, and then add it to the cup, use a white paper card, and use a copper rod to scrape and blow the hair dryer to match the color. After adjustment, weigh the color essence difference. Then use this amount to verify Zhen Min again.

I've also seen someone directly mix the color, that is, first weigh the amount of each color essence and then directly use the cup to tune, grind the color on the white tile by hand, and add it to the paint when the color is about the same, and it's almost there!

Toning, the most important thing is to be familiar with many hands, and there are not many clever skills.

1. Color fine color mixing, the proportion of leakage is very small, there should not be much harm, because it is cheap can also achieve the effect, of course, if you have doubts, you can use paint, but the waste is too big, the cost is higher. Transparent is the color essence, and opaque is used color paste.

2. First match the color on the white tile, and then pull the color concentration of the shading paper. When mixing color, first grasp the proportion, let a little resin, when mixing is like this, first use a cup to weigh 100 grams of 84 to be colored, and then weigh the total weight of the color essence used in the color, followed by adding it to the cup, using a white paper card, using a copper rod to scrape and blow with a hair dryer to match the slag and rotten color.

3. After adjustment, weigh the color essence difference. Then use this amount to verify again.

4. The color essence in the water state is easy to stir evenly, and the powder is not easy to dissolve, and it is easy to spray the panel.

5. The amount should be mixed a little bit, brush it 3-4 times on the small board, and the beam height will change after each brush, so it cannot be used as a standard.

It is to add color essence to the paint, add it gradually, not too much at once, and then keep stirring, repeating the comparison until the color you want is ready. This is the method of artificially modulating the color of the paint.

It is a chemical additive and dyeing method.

The color essence is added to the paint.

Do you do face retouching? And whether you're a home improvement or a furniture factory, you have to make it clear.

The raw material must be mixed white; However, the pigment must be the oil or primary color paint used in the wood paint, that is to say, the artificial blending method of purple mixed water wood paint = mixed white + red (oil primary color paint) + blue (oil primary color paint); The pigment ratio of mixed white + red + blue is 2:1:1 Chestnut color is brown, but I don't know what kind of paint my friend uses; Here is a brief description of the manual deployment method:

Red + Yellow + Black = Brown.

Transparent is the color essence, and opaque is used color paste.

The color is matched on the white tile first, and only the color density of the occlusion paper is pulled.

When mixing colors, grasp the proportions first, and then add a little resin.