Panel furniture edging?

Trimming is not whitening is the basic requirement of edge banding, many edge banding factories do not do well enough in the substrate color mixing, can only rely on the surface printing behind to adjust the color, although the surface of the edge banding tape looks consistent with the color of the plate, but as long as a trimming, it will leak out the color of the edge banding substrate. Therefore, there will be obvious color differences, resulting in obvious white leakage on the edge of the board, which will affect the quality of the product.

If you have already purchased this type of edging, in addition to returning it, you can also use the same color trimming pen for beautification.

1. Look at the hue and surface roughness of the edge banding, the color of the surface of the edge banding strip is also very important, and whether the color is close to the customized product and gorgeous. If the surface is very rough and there are pull marks, the quality is definitely not much better, which is the surface quality of the edge banding strip. It has little to do with the quality of the internal material of the edge banding strip, mainly the production process of the edge banding strip factory and the production technical skills of the employees.

A good edge banding strip is: the surface must be smooth, with no or very little blistering, no or very little blistering, with a moderate gloss, not too shiny or too matte (unless otherwise requested).

2. Look at the flatness of the surface and bottom surface of the edge banding strip, and whether the thickness is uniform, otherwise it will lead to the combination of the edge banding strip and the plate, the glue line is too eye-catching or the gap between the plate and the edge banding strip is too large, which will affect the overall beauty. Details determine success or failure, and often a small detail problem may bring about an embarrassing situation of poor overall effect.

3. Whether the edge banding and trimming are white, whether the surface of the bent edge banding strip is seriously whitish, and whether the background color of the edge banding strip is close to the surface color of the difficult plate. PVC edge banding strip is mainly made of PVC and calcium carbonate plus additives, if the calcium carbonate content is too high, there will be whitening of the edge, bending and whitening, etc., which proves that the quality of this kind of product is not good.

4. Whether the strength is okay and whether there is elasticity, high strength means good wear resistance, and the corresponding quality is better, and too high strength also means that the processing difficulty increases. Low elasticity means low wear resistance and low resistance to aging. In addition, according to the needs of actual production, it is generally necessary to manually trim the edge, which can be appropriately done as soft points, and the automatic edge banding machine can be appropriately made as hard points.

5. Whether the adhesive is evenly applied and whether it is easy to fall off during use.

6. Smell whether PVC edge banding strip has a taste, the products produced by using good quality raw materials generally have a small taste, if the taste is too large, it means that the quality of raw materials used in production is relatively poor. Shanghai Suyi furniture edging.

Plastic edge banding.

A kind of panel furniture edge banding process, its process flow is as follows: the workpiece is transmitted forward by the feeding belt in a fixed state, and the edge banding surface of the workpiece is pre-milled into a step surface by the pre-milling cutter by the pre-milling cutter, and then a step surface in the step surface is rolled by the rubber roller, and then the whole edge banding operation is completed by the skin edge banding and repair process.