The toilet lid was full and it was still pouring in

The buoy controls the switch of the pumping cover, and the switch is generally worn out after a long time, so it is not so sensitive. You can open the lid and press it manually, or lift it on it.

It is advisable to replace this sooner, it is a waste of water.

1. The toilet is constantly inflowing: see if there is any water flowing into and out of the pipe, assuming that it is, dispatch the valve. Whether the chain is too tight or too loose depends on the slack of only 1 or 2 links.

It is important to pay attention to whether the water valve in the home or nearby area has been turned off for any reason, which will cause impurities to enter the water pipe and reach the sealing gasket of the water inlet valve and affect its sealing function. Liquidate the surface of the inlet valve. Assuming it is still not processed, call the supplier to order a new inlet valve gasket.

2. Move the spool that was previously "locked" This is due to the build-up of calcium and minerals. Soak in a one-to-one mixture of white vinegar and water, spray directly on the spool, and persist for a period of time to dissolve the buildup and loosen it. 3. Water level scheduling in the toilet tank There is an adjustment clip on the float rod connecting the float, pinch the adjustment clip and move it up and down to dispatch the water level.

Generally, the adjustment clip is placed on the standard water level at the factory to achieve the best flushing effect, and there is no need to adjust it separately.

In this case, we can try to do a test check first: lift the water drift up with your hands to see if there is still water ingress, if not, it means that the position of the water drift is not suitable. At this point, it is enough to lower the water drift position, which can increase the buoyancy to close the inlet valve port.

If there is still water inlet after lifting the water bleaching, it is very likely that there is a problem with the components of the automatic water inlet valve, and you need to ask the water master to check and repair it. Toilet water tank overflow 2, the toilet water tank overflows from the side, just like putting the cup crookedly, and a trickle flows out of the water tank. The toilet bowl is constantly filled with water and overflows to the side, which generally means that there is a problem with the inlet valve, and the quality of the inlet valve is considered first, and then it is not ruled out that it is caused by improper installation.

If you used it well a few days ago and didn't touch the toilet and suddenly it overflowed, it means that the inlet valve is out of order, so you can replace it with an inlet valve of the same specification. If it is not installed properly, you can open the inlet valve floating bucket to see if there are any impurities, and if so, just adjust the orientation.