-
Anonymous users2024-01-23Lifting the ground requires raising the diameter of the sewer pipe by at least one height. In general, it is also necessary to pay attention to the toilet floor should not be higher than the outside to prevent overflow. You can raise the floor under the toilet partially, and keep the other heights unchanged.
It is best to raise the ground to not damage the floor slab, and the shifter is not easy to burst without pressure
There is no need to raise the floor to install a toilet.
Because the toilet itself brings back the water bend, there is no need to think about the floor. >>>More
1. Toilet shifter.
The toilet shifter is mainly aimed at adjusting the position of the toilet bowl in a small way, which is generally caused by the inappropriate distance of the toilet pit; However, the distance between the pits should not be too large, only within 10cm, and it will not work if there are more. >>>More
1. Plastic steel mud and plasticine are kneaded into strips, treated at the corner of the wall, around the water pipe, around the toilet, around the floor drain, etc., after the plastic steel mud is cured, it is as hard as the tile to ensure that these positions are permanently not cracked, not leaking, and not moldy. 2. German kinfoo invisible waterproof liquid (leakage buster) looks exactly the same as tap water, used to treat the ground plane or wall plane, specifically brush twice on the tile gap and brush the entire tile surface once, so that the whole surface can be treated to a drop of water, so as to ensure that there is no drop of water on the ground when there is any clear water will seep into the mortar layer under the tile, so that the mortar layer has been kept dry, and no water will leak to the damaged position of the waterproof layer. Therefore, the problem of water leakage has been completely solved!! >>>More
Casing is carried out inside.
Try to choose a pipe diameter that is as close as possible to a slightly smaller diameter. >>>More