How to lay pipes for hot and cold water in the bathroom?

Method 1: Close the main water valve first, and then put the faucet handle with a red and blue mark of about 8 mm, buckle it down, loosen the fixing screw counterclockwise with a flathead screwdriver, take off the handle, use a live wrench to disassemble the valve core of the faucet, open the upper part of the gland with a wrench, and take out the ceramic valve core inside. >>>More

Generally, the hot and cold water pipes in the bathroom are basically at a distance from the ground meters, this height is generally suitable for the washing machine and the mop bucket to receive water, if the home is ready to use the kind of automatic washing machine, it is best to keep it above the meter, the water pipe faucet can be installed when it is high, and other hoses can be installed to connect the water, and it is impossible to connect it if it is low.

There are two types of liability for this. First, all the losses upstairs should be borne by the project contractor, and second, look at your downstairs loss because the ground is not waterproof or caused by the plumbing contractor's construction, because the ground is not waterproof, the waterproof construction and the contractor have to bear the loss of the downstairs part, if it is your water and electricity contractor to do it, then the hydropower contractor is fully responsible. Negotiate first, but if the negotiation fails, you should consult a professional lawyer for specific matters and then take legal channels.

Labor wages? About 600.

The height of the bathroom basin and kitchen basin is 45 cm high from the ground. If the bathroom sewer pipe enters the wall, the height is 35-40 cm high. The distance between the hot and cold water pipe joints is only 14-15 cm for the shower mixture, and the rest of the distance can be installed and operated as long as it is good.