-
Anonymous users2024-01-23Unplug all electrical appliances in the room without power to see if they still trip. If it doesn't jump, there is a problem with the electrical appliance. If it is still tripped, remove the main switch box cover, remove the lower end line of the trip switch, and then see if the switch is still tripped, if it is still tripping, the switch itself is faulty, and it is good to replace it.
If you don't jump, then there is a problem with the hidden line, which is more difficult to deal with.
-
Anonymous users2024-01-22This problem is not a problem, just disconnect the electric switch, turn on the socket to see if the power cord is firmly connected to the socket? Look at whether the contacts in the socket are deformed? If it is deformed, use a screwdriver to get it over, and the appliance will be in full contact with the plug.
The switch of the bathroom shower is called a mixer. Yes, you can change it. Unscrew the two roses against the wall, and then install a new one, 1Rose is tight in the direction. On the contrary, loose, 2The tight process must be mastered well. Just be tight enough not to leak. If it's too tight, the rubber pad will be broken. >>>More
The air switch tripping is generally caused by the load exceeding the rated current of the air switch, it is recommended to check whether the load circuit is working normally, if it is working normally, it is necessary to replace the air switch with a larger rated current, and at the same time, it is necessary to consider whether the wire diameter of the wire can meet the use requirements.
The switch is broken, just find a similar switch to replace it.
Generally, there are two reasons for water leakage in the bathroom, one is water seepage on the ground, and the other is water seepage caused by broken water pipes. The manifestation of this situation is that the leakage is continuous and uninterrupted, and sometimes the leakage amount is constantly increasing, such as closing the main valve of the water reform balance, and the leakage will be reduced immediately. First of all, the nuclear inspection team observes the leakage and makes a record, and then turns on all the faucets, toilets and drains the water multiple times, and pours water into the leakage.
1. Try not to damage the original waterproof layer: If the original waterproof layer is not damaged, there will generally be no leakage after moving in. However, the waterproof layer is easy to be damaged when renovating the ground, and if it is accidentally damaged, it should be repaired in time to avoid leaving hidden dangers. >>>More