-
Anonymous users2024-01-23If the floor tiles in the bathroom are replaced as a whole, it is recommended to remove the toilet;
After the waterproofing, before the tile is paved firmly, it is recommended not to use the bathroom, mainly to avoid walking on the tile before it is dry and solid, resulting in the hollowing of the tile delamination;
After the tile is paved, the toilet is installed;
Tile paving is a basic skill of bricklayer (inlay worker), and the bricklayer is mainly responsible for the construction of wall masonry, cement mortar plastering leveling, tile paving, waterproof construction, etc.;
If you only buy floor tiles for the bathroom, generally speaking, the problem is not too big. You can buy it nearby or buy it online.
The issues that require special attention are as follows:
When disassembling tiles, do not damage the pipelines on the ground;
In the process of dismantling and tiling, be careful not to pour muck into the sewer pipe to avoid blockage;
When doing ground waterproofing, it is necessary to pay attention to the waterproof construction of the wall-ground junction part.
If you want to use the black bricks underneath, you must have this height. The waistline should be above the bathroom countertop (about 900 height) and will not be covered. It is possible to reduce the white brick in the middle a little (to 1.8 meters). >>>More
Hello, you don't need to seep water hard, the gap will be slightly better, and the effect will not be obvious. The quality of the tiles is not good, and the good tiles also have water seepage, but they are less, and they can't see more
If you can't pry it, you usually smash it directly, and then hit it again with a percussion drill.
That's a good idea. And it's also relatively easy to implement. The specific method is to fill the caulk first, and then raise the gap to a depth of 2 3 mm, so that even if the caulk solidifies, it will not affect you to make a beautiful sewing agent.
The simpler way to do this is to remove the tiles, make a layer of waterproof paste, and then re-apply the tiles with tile adhesive.