How to paint new furniture can have the effect of white through wood grain, please have experience i

It is not recommended to use gouache pigments, because the adhesion between water pigments and wood is not good, and it is easy to separate from the layer after painting.

It is also not appropriate to mix the varnish with some white paint, and the hiding power is not enough.

The white through wood grain effect is called open lacquer finishing, the first condition is that the pipe hole on the surface of the wood must be relatively large, such as ash, oak, oak, elm, etc., if the pipe hole on the wood surface is relatively small, don't bother, no matter how to do it, there will be no ideal open effect.

If the above conditions are compounded, the bottom coat only needs to be sprayed with white paint, it must be sprayed with paint, not brushed, sprayed can be sprayed very thin, the brush will be very thick, too much infiltration into the pipe hole, it will also block the pipe hole, and the effect cannot be achieved.

Only the method of spraying can have the best effect, and brushing is useless. It is required to spray white primer on the first coat of the panel without painting, and the paint is diluted, and the panel putty cannot be scraped completely. Patching nail holes is.

Otherwise, it won't have the effect you want. Finally, two coats of white topcoat are sprayed. If the furniture has been painted, then don't bother, nitro paint is too toxic, choose a high-end and yellowing quality is guaranteed.

The paint is diluted during construction, which has an impact on the quality. I've done a lot of white paint and it turns yellow within a few months

It's very simple, if it is white to cover the bottom, use a nitro transparent bottom to make a primer, and spray nitro white paint after polishing and smoothing. The effect is all white, and there is a wood grain pattern (all of which are covered from the bottom, and the wood grain is shown by uneven heights).

Another is to rub it with white paint with poor hiding power to make the catheter appear white, and then spray a transparent base and transparent topcoat. The effect is translucent and wood-grained!

Do not use polyester paint, choose to use nitro paint, white stubble sanding after brushing, deepen the wood grain effect, evenly apply the color paint to the substrate with a clean rag (be sure to let the paint eat into the wood grain), after drying, use elastic gauze to polish smooth, do not leak, and finally spray color paint.

I think it should be able to achieve the effect you want.

The comrade downstairs is talking about a high concentration of hydrogen peroxide + ammonia water as a catalyst, which is used for wood bleaching, and this method is not suitable. If you are inexperienced or do not handle it well, it is easy to get flowers in the wood or burn yourself.

There is a raw material that turns the wood white, I don't know the specific name, I have to use it, just rub it with the raw material a little bit (liquid colorless industrial raw material), the wood becomes white and hard, just like the white wood in the high-end bathroom.

If the effect of spraying white paint is very different (the effect is not wood but white paint) can not achieve the effect you want, it is recommended not to do it ugly.

If you find it, it is recommended to bleach the water with a spray gun spray on the low air pressure, pay attention to protection, and stick to the hand to collect the time during the day haha.