-
Anonymous users2024-01-23Under normal circumstances, it is normal to spark, when the plug is just in contact with the power supply, because the electricity demand is relatively large, it is responsible for the instantaneous increase, and the current can not be completely transmitted immediately in the process, this moment is a virtual connection will produce a spark, especially when inserting the plug, under normal circumstances, there will be no problem you said, your situation is likely to be damaged inside the socket, and there is an instantaneous short circuit phenomenon when the socket is put in, resulting in tripping, you can find a power fuse box, and push the air switch of trip protection downwards to push up, In this way, there is electricity, for example, pushing up the air switch will jump down in an instant, that proves that the short circuit problem has not been solved, find the problem switch to replace, if the air switch is pushed up, the power supply is normal, to observe whether there will be a trip phenomenon when using the socket again, and then there must be a problem with the socket, it must be replaced, if the hands-on ability is not strong, it is recommended to find an experienced person to check, after all, it is electricity, it is very dangerous, tell you a little common sense, remember not to grab it with your hands when you contact electricity, Touching it with the back of your hand, it's silly to say it, who will touch it if there is electricity, but there is always a last resort, just keep it in mind.
-
Anonymous users2024-01-22It should have tripped, check the distribution box of your home.
-
Anonymous users2024-01-21Poor contact between the plug and the socket will cause the ignition to become hot, be careful to cause a fire, it is recommended to replace the socket with a good one for safety.
Hello, the mains power is 220V, which can only be used for two-phase electricity, while three-phase electricity requires 380V voltage, so it cannot be used.
The computers at home are all desktops?? None of them have wireless capabilities??
It's as simple as using a wire to lead from the original socket to the new socket. The wires on each interface can be connected correspondingly, that is, on the L interface on the live wire socket, on the N interface on the neutral wire, and on the ground wire identification interface.
The hair backrest and the sitting are not connected, how to repair the old sofa and the new one is not connected, then don't, replace it with a new one.
The water vapor in your house is too large, so in this case, it is better to use a waterproof socket. Otherwise, water vapor is more likely to enter the socket and cause danger. Although the waterproof socket is not fully sealed, it still has a certain airtightness.