The living room light switch controls all outlets

1. If the living room light is not lit, the zero line of the living room light is in poor contact or disconnected. (e.g. damaged by a drill bit).

2. The living room light switch controls the socket, and proves that the live wire of the socket is connected to the output line of the switch (yellow wire), and the socket should be connected to the live wire and the neutral line of the output of the leakage protector. The electrician is connected to the lighting line nearby, and the lighting line is not through the leakage protector, which is not safe!! Quickly change to the output line of the leakage protector.

If this is the case, then it must be a switch drawn from the wire, but I have two questions: first, some projects are not very careful, so sometimes some wires will be forgotten when wiring, so sometimes the wires in the bathroom and kitchen will be the switch that leads from the live wire on the top, and such a switch also uses 4 square wires (because the bathroom will have bath bombs, etc., so most of them are 4 square meters of wires), if this is the case, the single wire can also control the light after connecting the live wire.

Second, there is also such a problem out of the line, sometimes workers will forget to take the line of the bathroom, so there is a socket wire that can be drawn from the light line, then the use of the wire may be the wire, even if it can be a separate ignition wire, but it will be worse for electric water heaters.

So I suggest you open the switch and the socket wire first and take a look, if it is too thin, you should pay attention.