-
At present, most of the toilet installers do not strictly follow the specifications when installing the toilet.
When the toilet is installed, after punching the hole, the expansion bolt hole is poured into the waterproof, and then the expansion bolt is fixed with the ground.
-
Just debug it, if the accessory is broken, replace the accessory, this is not expensive.
-
In fact, it doesn't cost much money, go find a master to help you fix it, about 100-200!
1. The toilet is slightly clogged.
Generally, the toilet bowl is clogged by toilet paper, sanitary napkins, towel rags, etc., and if you flush it more, it will be cleared by yourself. If it is greasy, then a basin of boiling water can melt it. >>>More
What to do if the bidet toilet is clogged; The best and easiest way to do it is ... >>>More
Ten hail with disadvantages and ten thousand sell the knowledge of the cold source family.
This should be the connection (chain, rope, pole) between the plug in the tank and the button (handle) disconnected, this phenomenon will occur, the drain handle button on the side, you can directly open the lid of the water tank to view, connect it can be used, if the button is in the middle of the top of the tank cover, the outer ring of the button can be removed by rotating the opposite hand with a tool, and then open the lid to view, connect the 、--
Solution: Add caustic soda or oxalic acid and wait for about 15 minutes; If the blockage is not severe, then as long as you continue to flush a large amount of water into the toilet, you can usually unclog the toilet. If the blockage of the bidet toilet is severe, then you can use a dredging tool such as a water pluck to unclog it.