-
Anonymous users2024-01-23Buy glass glue to block it yourself, and there are more than 30 yuan to get it. If you hire someone to do it, the cost will be much more than that. (The glass glue and the gun are about ten yuan each).
-
Anonymous users2024-01-22Dig the best permeable waterproofing can be done by yourself.
If the cement surface is to be waterproofed, use the super permeable waterproof guard of the black gold steel to do waterproofing (if it is incomplete, use the dug beautiful butadia glue to fill the complete and then do the waterproofing).
For the tile surface, first check whether the filling of the tile gap is complete (if it is incomplete, fill it with dug beautiful butadia glue, and then use the black gold steel stone tile type to do waterproofing).
-
Anonymous users2024-01-21It's good to buy glass glue and go back to make up for it. Waterproof!
-
Anonymous users2024-01-20It's very simple, find a plugging master to help you deal with it.
It is recommended to go to the online cement repair expert to buy GT-28 crack repair paste, which is very hard, waterproof and not easy to fall off after repair. >>>More
Let's clean the toilet.
Go to the supermarket and check it out, a lot. >>>More
I believe everyone has encountered a blocked toilet, and it can also be said to be a more common thing in lifeNot only does it directly affect normal life, but it puts us in an awkward position? In fact, after the toilet is blocked, you may not immediately turn to a professional toilet company, you can try it yourself, so what are the methods of flushing the toilet? >>>More
The principle of the flush toilet is mainly the siphon principle, and the schematic diagram of the flush toilet is also based on the siphon principle. The "pumping" of the flush toilet refers to the S-shaped bend under the toilet, and when the water surface in the toilet exceeds the high point of the S-bend, the siphon phenomenon is formed, which can pump the water and dirt of the toilet together. Until only a small amount of water remains, the siphon destroys, leaving a small amount of water, forming a water seal. >>>More
This is because the plug did not reset with the flow of water when you flushed the toilet last time, you only need to press the flush button again with your hand, and hear the sound of popping in the water tank is the plug reset, and you will not have this situation again when you flush the water in time, please adopt.