-
Anonymous users2024-01-23First of all, it is necessary to determine whether it is overload tripping or leakage tripping, it is said that 32 An is not small, and the brake can not be changed blindly. Should first ask the electrician to use the shake meter to measure the insulation of the line and electrical appliances, if not up to standard, update the circuit or electrical appliances is the root cause, you can also change a leakage insurance first, to eliminate the possibility of leakage and misoperation.
-
Anonymous users2024-01-22Current (A) Voltage (V) Power (W).
You can do the math yourself.
-
Anonymous users2024-01-21This has nothing to do with whether you take a line or not, it depends on whether the load of this line matches the switch. My house is just a line to walk, not tripping.
Check whether the water heater is powered on, and then see if the water heater can still work properly?
There may be two main reasons: 1. The power cord connecting the bath bomb has a small wire diameter and a large power bath bomb; 2. There is a virtual connection between the bath bomb and the power cord connector.
It doesn't matter if the distance is close, the main thing is that the close distance leads to inconvenient operation or installation, and it is recommended to separate them from each other.
If the empty opening does not have a leakage warranty, then the possibility of short-circuit fault of the electric water heater is relatively large, and if the empty opening is leaked with a leakage warranty, the possibility of leakage of the electric water heater cannot be ruled out, and a comprehensive detection and analysis is required to eliminate the fault.
In principle, as long as the power supply capacity is large enough, it can be connected by sharing a socket line, but the power of these two types of equipment is not small, and the working power is about 4KW at the same time, and the main line of power supply is best 6 square copper wire, not less than 4 square meters.