If you want to eradicate the bathroom tiles in your rural hometown, come and take a look at these ti

Bathroom tile removal trick 1: dismantle bathroom utensils back.

Dismantle bathroom appliances such as wash basins, mirrors, hooks, water heaters, etc., and finally remove the ceiling. According to the construction habits of the construction team, the sanitary appliances can be dismantled before all walls are brick-knocked, or they can be interspersed with brick-knocking. When removing bathroom fixtures, it is necessary to communicate with the owner beforehand.

If the bathroom utensils need to be kept for use, be careful not to damage the bathroom utensils when disassembling them.

Not all bathroom appliances need to be dismantled immediately, and the disassembly of the toilet is left after the bricks are knocked out. To prevent the tiles that fall when knocking bricks will smash the drainage pipe, or fall into the drainage pipe and cause silting. However, if the owner needs to keep the toilet, you can use wooden boards or sturdy materials to stand on top of the toilet before construction to prevent falling tiles and damaging the toilet.

Bathroom tile removal trick 2: Bathroom tile removal.

After the bathroom appliances are removed, the wall tiles can be disassembled. Demolition is generally knocked from the bottom of the wall to the top, from the edge of the tile to the inside, and it is also necessary to choose the appropriate knocking force according to the position of the demolition. Brick knocking starts from under the wall, starting from the edge of each tile.

If you knock on the top tiles first, there are more tiles piled up on the ground, blocking the tiles under the wall, which is not conducive to demolition.

In addition, in the process of knocking bricks, if the tiles on the ground are not cleaned, so as to avoid excessive accumulation of tiles, slow down the construction progress and cause construction accidents. Since the bathroom of the second-hand house was waterproofed before, it is necessary to pay attention to the treatment of the waterproof layer when knocking on the bricks, and communicate with the owner to see if the waterproof layer is removed.

The old waterproof layer is generally not knocked off, after knocking the bricks, on top of the original waterproof layer, and then make a thin layer of waterproofing to improve the waterproof ability of the bathroom. But if the homeowner needs to knock off the waterproofing and do it again. Then the bricks need to be hit to the soil layer or to the bottom.

When knocking on tiles near sockets and faucets, knock slowly, carefully finding the direction of the wires and water pipes to prevent damage to the wires and water pipes. If the electrical wiring or water pipe has been damaged, it should be repaired in time to avoid leaving more follow-up work.