-
If your electrical appliances are turned on at the same time, and the total power reaches 10,300 watts, you need copper wires with a cross-sectional area of more than 6mm to power them, and the power supply radius must not exceed 50 meters, and you need an air switch with a current greater than 60 amperes.
-
If it is a single-phase 220V power supply, the current of the kilowatt electric water heater can reach about 35A, and it is safe to use 6 square meters of national standard copper wire, and if it is a three-phase 380V, the current is about 20A, and 4 square copper wires are enough.
-
Don't just think about your internal wiring, a single bathroom is more than a dozen kilowatts, and other electrical equipment in your home, first look at what is the installed capacity of your home power grid? Don't be top-heavy!!
Under normal circumstances, the installation of electric water heaters is directly responsible for the manufacturer, but if you are more worried, then pay attention to the following points: >>>More
It depends on the structure of your home. If the kitchen and bathroom are next door, choose a gas water heater, and if there is more than one room apart, choose an electric water heater, because it is inconvenient to adjust the water temperature from a distance.
It is generally placed in the toilet and hung on the wall.
No, when the house was built, it was considered, the water heaters are equipped with leakage protection, and the switch box also has leakage protection, it is useless to have more, and the general bath bomb should not be leaked.
The reasonable height is as follows: the socket of the electric water heater is 1800-2000mm, and the position of the electric water heater should be considered. >>>More