-
1. Prepare the disassembly tool: Phillips screwdriver.
>2. From the inside to the outside, from top to bottom, take out the screws.
>3. Until the gap is facing the vertical board, you can remove the partition.
> the design of the partition, take out the partition nail with the bite insert and place the partition in a suitable position. Saw off the middle of the partition directly, and after removing a screw underneath, sawed off the partition or smashed the partition. At this point, the three-in-one wardrobe has been disassembled.
-
Remove from top to bottom to protect the integrity of the board, as well as small parts such as removed screws, be sure to keep them. It is convenient when it is installed.
-
This is very simple, the three-in-one accessories should first take out the lock in the round hole, and then you can disassemble the screw, and the whole board of the wardrobe can be removed.
-
First of all, the link door panel and the hinge of the outer mountain were removed, and then the back panel was dismantled after the door was removed, and the top and bottom panels were very simple, it was best to find a helper, and it was not easy to get it alone.
-
You can go to the master of the wardrobe and ask him to help disassemble it, so that there is no mistake. Don't mess around with it yourself!
-
How did you assemble it at that time, did anyone assemble it with you, you can recall, whether there was a manual or something, or where did you buy it from, and who you asked to go.
-
It's better not to dismantle it. In case the screw mouth is loose, it will be unstable. If you really want to dismantle, it is recommended that you find a professional.
Hello landlord, you can refer to the following methods, I hope it will help you1. Place a dehydrating breather in the wardrobe; Generally, supermarkets buy it, a few dollars a box; >>>More
It depends on what causes it. If it is bent and deformed for no reason, it is a quality problem, and you need to ask them for an explanation, if it is caused by the weight of the item you place, it is your own reason.
Take it out to dry it often, and you can buy something moisture-proof, or you can only move the cabinet
You want to design according to your own requirements, and it is too difficult to find a good carpenter. When you go to the furniture factory, you must clearly explain your needs, so that you can succeed immediately.
It seems that solid wood is better to be painted, and not to use Boeing films.