-
Anonymous users2024-01-23The water heater can be led out by punching holes in the wall. The shampoo bed can be placed nearby.
-
Anonymous users2024-01-22You can put the shampoo bed anywhere, and you can extend the hot and cold water pipes to other rooms.
-
Anonymous users2024-01-21Just choose a new corner and install a set of shampoo equipment, it is impossible to let guests wash their hair in the toilet, right?
This should be the water heater inlet and outlet pipes in the filter screen is blocked, close the water inlet valve, open the valve to the water heater connection pipe (including the pressure reducing safety valve), find the filter screen to clean it, and then install it back in place, you can not operate it, you can find the property department or other maintenance personnel to operate.
You can use a long impact drill bit to make a hole in the wall, and then pull a special line from the main air switch control box to connect to the toilet electric water heater through the hole in the wall, as for the ground wire, you can find a steel bar to hit 50 cm in the ground, it is best not to connect to the lightning rod ground wire, please accept.
When you flush the toilet, the sanitary ware in the toilet will automatically enter the water to produce a water pressure difference, so that the water-gas linkage switch of the gas water heater will start to work, and the gas water heater will turn on. Solution: Water valves can be installed on the inlet and outlet pipes of the gas water heater. >>>More
If the toilet does not have a suitable load-bearing wall, you can install a bracket from the top or beam to support the water heater. >>>More
The water heater is started by the flow of water, and the filter at the outlet of your sink faucet is blocked, so it can't catch fire. You use a small wrench to remove the filter from the outlet and clean it up, and then you can start the fire.