At home, last night, with the heat quickly, as soon as it was plugged in, the kitchen wires lit a fi

Wire ignition cause:

1) The fast current of heat is large, 2) the wire joints are unqualified, 3) the humidity of the kitchen is high, and the adhesive tape is not tightly wrapped and the joints are oxidized.

Handling suggestions: 1) Pull down the main switch.

2) Disassemble the ignition place, flatten the thread end with pliers, and scrape the oxide layer with a knife. If it is two wires, they should be docked: the two wires are crossed, the left hand is pressed to the left of the intersection with a large plier, and the right hand is clamped with a sharp nose pliers to clamp the end of the wire and press around the other line; Then press around the other side, no less than 6 turns on each side.

Wrap it with electrician insulating tape, first.

The first and second layers are tightened hard, and each circle of adhesive tape presses half of the width, and the third layer of 6 circles cannot be pulled to let it stick to it naturally.

If there are more than three wires, use another same wire to press them together, not less than 15 turns, and finally fold the middle wire back to two or three, pressing the outer ring wire without going backwards. The method of wrapping the thread is the same as above.

3) Close the main switch.

It should be poor contact. Turn off the power and reconnect the wires at the lighter, be sure to tighten them tightly and wrap them in insulating tape. Good luck.

Short circuit, last time I repaired the lamp at home, I forgot to glue the result of the power supply, the wire burned, the fire flashed, I was so scared that I immediately unplugged the power supply, and stood there for a long time without moving.

Go to the relevant departments to fix it, and pay attention to it.

It is estimated that the wire skin is burned, and you turn on the light and there is a slight short circuit.

It may be that the aging wire that has been used for many years is burned and connected with the hot fast current is too high, and it is best to replace the aging wire to avoid failure, safety first