-
Anonymous users2024-01-23If it is a newly renovated house, it is the reason for the faucet, try to change the faucet, if it is an old house, it may be that the rust in the faucet has entered the pipe.
-
Anonymous users2024-01-22The main reason comes clogging.
Overhaul step source suddenly:
1.Put the bottom of the faucet first.
If the water outlet is normal, it is blocked by the DAO filter.
2.If the above problems are not solved, you can close the main gate, remove the lowest faucet, and then open the main gate, discharge the impurities of the pipeline through drainage, and finally install the faucet. (The removed faucet should be reversed to facilitate blocking).
Through the above maintenance, the problem was found and repaired.
-
Anonymous users2024-01-21Is the triangle valve open to the maximum?
Is the hose connecting to the faucet thin or blocked?
If the speed of water inlet is adjusted, the angle valve outside is adjusted; If you talk about adjusting the water level in the water tank, you first open the lid, look at the float, how to adjust its level, and think about it, the water tank is varied, you can't generalize, and it will be solved when it is adjusted.
If the amount of water is the same, it should be red and blue, and red represents hot water.
There are several reasons for this. 1: Water pressure problem, do you have a large water flow rate in the wash basin and kitchen faucet? If it's not too big, the water pressure is not enough. >>>More
In the toilet tank, there is a body with a bayonet on the side of the float, which controls the height of the float. The higher the float, the larger the amount of water, and vice versa.
Increase the amount of water in the tank, raise the water level, and the water that goes down will naturally increase the amount of water.