The distance of the toilet sewer pipe, I install the toilet sewer pipe according to how many inches

The installation of the toilet sewer pipe must be accurate, and the socket should be glued, and all plugs must be plugged to the end. After the installation, the hole through the floor slab should be carefully filled with cement mortar to prevent water seepage in the future. After the water pipe is ready, the reserved water nozzle should be wrapped to prevent the cement from falling.

The size of the sink has some minimum control, the minimum width is 550mm, and the 600mm bathroom has been reduced to about 300mm in order to save space, but even if this is done, the washbasin is not only 300mm wide, and the washbasin must be highlighted, so it is inconvenient to place things. In addition, the key is to leave a 550mm headroom size from the center of the washbasin to the walls on both sides, that is to say, there must be a headroom of 1100 to put your counter, otherwise it will be lame to use, so you can synthesize everyone's opinions. In order to save money or even avoid the washbasin, some people need a floor-to-ceiling washbasin and put soap or something. >>>More

The toilet reserves the distance between the sewer and the wall, and the toilet selection tool can be 30 cm to 40 cm according to the room type of the toilet and personal preferences, which is relatively normal, and the strong one who can reserve 20 cm in actual operation, and the actual distance from the center line of the sewer, the actual distance of the bridge deck can be 32 cm to 42 cm, and there will actually be an error of 10 cm, which is very normal.

Towel racks are generally between fifteen and twenty, and the lower end is one meter five above the ground.

If the bathroom sewer pipe exceeds the window by two tons, it cannot be renovated, and it should be negotiated with the developer.