-
Anonymous users2024-01-23According to my previous experience in loading toilets, it can be reluctantly installed, as long as you don't use the ground flange (special for toilets), but it also depends on luck, because the mouth of each toilet is more than the size error point indicated on the package, but most of the 400 are 380 390 kinds, but it is not certain, there are also standard standards of 400, so it depends on your luck.
-
Anonymous users2024-01-22THE ACTUAL DISTANCE BETWEEN THE TOILET DRAIN HOLES OF THE BRAND IS LESS THAN THE CALIBRATED SIZE OF 20MM. The manufacturer's calibration is of his significance: that is, after installation, the toilet can be 20-30MM away from the wall (wall tile surface), which is good and scientific
That is, there is no dead end, otherwise, the wall will not be able to be taken care of when used in the future, and the dead corner of the wall cannot be cleaned. What is indicated on the instructions is correct, there is no doubt.
Note: Domestic big brand toilets, (including joint ventures, imports), the drain of the toilet is protruding, this part of the bottom outer diameter of about 90MM, the lower outer diameter of about 75MM, the brand is different, but the same. That is to say, when installing the toilet, this protruding part should be extended into the 110 drain pipe mouth, which is the first best installation state (do not use the manufacturer or dealer to install, they will not be so careful), that is to say, the front and rear position of the toilet in the 110 drain pipe mouth There is nearly 30 front and rear adjustment distance, and your situation is still conservatively said that there is still 10MM forward movable space (not counting the 20MM difference of the calibration).
So, there is no problem.
Hold on: You can move the toilet to one side, see for yourself the drain and measure the actual hole spacing.
-
Anonymous users2024-01-21Oh, it's best to change the eye distance to the right one, if you have to install, then before installing the floor tiles, you need to put a shifter underneath, you can also install it.
-
Anonymous users2024-01-20No problem, this will not have an effect, except that the distance between the toilet and the wall will be slightly larger. Sometimes the sales don't know how to install very well, you can call to consult their after-sales service.
-
Anonymous users2024-01-19It depends on the skill of the installer, if the toilet flange and the sewer are not very matched, the spout can be properly polished to match the flange, and it is necessary to install carefully and have a certain installation experience.
-
Anonymous users2024-01-18You can consult the plumber, with a turnaround pipe can be solved, may raise the ground.
-
Anonymous users2024-01-17This is no problem, you can install it directly, you don't need a shifter, after the shifter is installed, the diameter of the drain becomes smaller, it's best not to use it, the small nozzle of the general toilet is smaller than the PVC pipe diameter, so it's not a problem.
To change the smart toilet seat, you must first measure the size of your toilet mouth with a ruler, and then you must match the size of your toilet when purchasing, not the first to look at the brand. Second, there must be a solid socket next to the toilet at your home, so that the smart toilet cover can be used when you buy it home, because the smart toilet seat uses a large amount of electricity, don't prepare to use a temporary socket line, which is very unsafe.
The two roses you see in your second image turn left until the rob hat is removed, and the toilet seat is ready to be removed.
The supermarket upstairs said that the dredge like a spring is useless, and it can only be used for some slight blockages The landlord has found a professional dredge pipe that does not work, it seems that the landlord can really only dismantle the toilet and dredge it Because the landlord has tried to dredge the pipe professionally, it means that it is not the toilet itself that is blocked but the sewer pipe is blocked The sewer pipe of the squatting toilet is different from the general sewer pipe, and there is an extra trap in the pipe, which is to prevent the odor from coming up, and the toilet toilet itself has a trap, so there is no need to install a trap in the pipe, just like the current toilet sewer pipe is almost not equipped with a trap >>>More
If you don't like yellowing, you can change the toilet seat directly.
First of all, the range of choices about the brand of the toilet is still relatively large, of course, when choosing the toilet brand, it is still necessary to choose some well-known brands, so as to ensure the quality of the product. The common toilet brand in general personally thinks Wrigley is a very good choice. And the keyboard brand is very stable in quality, and it also has a very good reputation.