My TV at home is wired, why is there no signal when I turn on the kitchen light

Updated on Kitchen 2024-04-26
2 answers
  1. Anonymous users2024-01-23

    When the fluorescent lamp is turned on and the starter is turned on, the high voltage breaks down the gas in the fluorescent lamp, thus igniting the lamp body. In order to reduce costs, some starters remove the high-voltage protection part, and this high voltage enters the mains circuit and interferes with other electrical appliances. Your fluorescent starter is interfering with your wired set-top box, try a different starter.

  2. Anonymous users2024-01-22

    You check the power socket and wiring to see if there is a false connection or wrong connection caused by the voltage drop after turning on the light

Related questions
Why is it that when I turn on the range hood and go into the drain, the wind blows out in the toilet
6 answers2024-04-26

Because the doors and windows are closed, it can be regarded as a closed environment, and the range hood is to pump gas out, so that the indoor air pressure becomes smaller, then there will be gas to fill in, so the only way to make gas in is the bathroom - the sewer >>>More

Why the TV is plugged into the living room is clear, but the cable plugged in the room is not clear
10 answers2024-04-26

Explain that there is a problem with the TV signal connected to other rooms, mostly because of the poor quality of the distributor and cable, or the wrong connection joint during installation, resulting in a short circuit, if there is no problem with the quality of the distributor and the cable, you should check each joint, whether there is a problem with the connection, if the cable quality is not good, the cable with good quality should be replaced. If the cable TV signal line from the living room to other rooms does not use a distributor or branch, but uses a straight-through connector, it should be equipped with a distributor or branch, so as to ensure that the TV in each room works well.

Why did the bath bomb in the bathroom start to fire as soon as it was turned on
1 answers2024-04-26

There may be two main reasons: 1. The power cord connecting the bath bomb has a small wire diameter and a large power bath bomb; 2. There is a virtual connection between the bath bomb and the power cord connector.

The chandelier in my living room, the ballast is broken, it burns as soon as it is opened, and it bu
4 answers2024-04-26

At the output end of the ballast, you use a multimeter to measure whether there is a short circuit

The TV in the bedroom ignited as soon as the main gate was opened. After that, the power went out, b
5 answers2024-04-26

It's connected, it's the live wire, and the zero line is serialized together, or it's the problem of the transfer, and one of the main reasons is that the main switch wires don't meet the requirements, and I promise that it won't be anything else except for these problems.