I bought a FAENZA automatic flushing toilet, pressed the flush button, and it gurgled and it just di

See if the toilet outlet is clogged and pass it; Clean the inside of the toilet tank; See if the water level is too low, if it's too low-key and a little higher;

It should be the plug seal in the water tank, and it should be good to move the button a few more times, or open the lid of the water tank to take a look, and the lid of the water tank cannot be opened to temporarily close the angle valve under the water tank, and wait for others to come back and look again, or you can find the property department to repair it.

You remove the lid of the water tank and press it directly with your finger, if the water can be flushed properly, it is not broken. Then adjust the direction of the button on the lid, and it should be easy to press in the future.

There are 2 flush buttons on the toilet, in simple terms, the small button flushes a small amount of water, and the large button flushes a large amount of water. >>>More

You take off the toilet tank cover, see a cylinder inside, you see that the button does not bounce up, you press it and it pops up, you press a few more times, it is easy to use, you pour the toilet cleaning things into the cleaning point to clean it can be used for a long time, remember to press vertically when pressing in the future, it is not easy to break, the usual use and maintenance is very important.