-
Anonymous users2024-01-23Most of them are Mohs 6 tapers, the taper C is, and the outer cone diameter is , mainly depending on the specifications and models of each manufacturer and the size of the spindle through hole to determine the Mohs taper.
Number of taper C outer cone diameter basic size D01
It is impossible that you must have changed the wrong gear, played the direction of the wire, the metric system and the imperial system have to change the hanging wheel, some need to change the gear, the direction of the metric system is to the direction of the chuck, unless the wire, but the reverse knife reversal can also pick the wire, you are not this thing to pick the wire experience less jokes, the wrong block knows no.
More than 90% of the oil leakage problem is because the rubber seal inside the gearbox has been alternating between cold and warm temperatures for a long time, resulting in the loss of a large number of plasticizers and softeners in the sealing ring, and the problem of corrosion, aging and hardening.
Spindle? Generally, there is a taper pin fixed, take the taper pin, loose nut, adjust with a dial gauge, adjust the outer circle of the car, about 80 times long, measure the taper with a micrometer, see whether the cone is or the reverse cone, and adjust it by the headstock with the dial gauge.
1.Carbon deposits can cause insufficient combustion of gasoline and cause the engine to shake. The impact of engine carbon deposition on the car is quite large, first of all, to reduce the engine power, that is, to make the power output uneven and gradually decay, in other words, more and more powerless. >>>More
Now CA6140 lathes are not the same, each manufacturer is different, you have to make specific drawings for specific analysis.