-
Anonymous users2024-01-23Well, first use a little gypsum sticky powder and water to make a paste, fix the wire, dry it thoroughly, and then use gypsum powder to make up the level, grind it with sandpaper, and brush the paint.
-
Anonymous users2024-01-22The unused chandelier wires are wrapped with insulating tape, coiled into the wire duct, covered with tin foil, putty and whitewashed, slightly marked, and used for later use.
-
Anonymous users2024-01-21The protective layer of the plate is generally more than 2 cm, and the groove can be chiseled 1 cm to take the square light line (the trunking is too shallow to trace the pipe), and then the subsequent construction can be carried out by leveling it with cement mortar.
-
Anonymous users2024-01-20If you want to cover the line of the ceiling lamp, you can hide it directly in the ceiling.
Install a trunking on the wall and put the wire inside. You can go to the hardware store to buy the trunking, and tell the boss about your situation after you go, and the boss will tell you what kind of trunking it is.
The switch of the ceiling lamp line triple needs to put four lines, a power line is connected to the L end of the three switches, and three lamp control lines are connected with one end of the three lights, and the other end of the three lights is directly connected with the power zero line.
The main line goes between the two floors, and at the first light hole and connects a pair of lines to the light hole. The 12 lights are divided into 3 groups and controlled by 3 switches.
You might want to consider installing a bollard lamp.
It is best to use two expansion screws.
The bolt is 120*8, and the steel plate drilling screw is fixed and connected, so that the safety factor is higher. >>>More