-
Anonymous users2024-01-23As long as the waterproof project is done, there will be no leakage, and the main reason for the water accumulation may be that the floor drain is relatively small, or the brick laying should not pay attention to the brick should be inclined to the floor drain, and the water will flow faster.
After the bathroom is discharged, it is necessary to do a closed water test, that is, to block the door and put water in, and after 12 hours, it is qualified if there is no leakage.
The amount of work is not small, hehe.
Water leakage is not going to be the main recommendation for you on a few points: >>>More
In fact, the toilet should not leak when it is installed with a booster rod.
Then it depends on whether the layout of the drainage pipe is suitable or not! Under normal circumstances, there will be no obvious crossing!
Water leakage can be detected by a closed water test.
The closed water test needs to be done after the waterproofing is done, and it can only be done when it is dry, and in the case of no waterproofing, Qiancheng should not do the closed water test, otherwise it is likely to cause serious problems downstairs. >>>More