-
Anonymous users2024-01-23See which form of expression it is: 1, it has been leaking and never stopping, and it is getting worse and worse This situation should be the only way to dig the water pipe on the bathroom floor.
Open the water replacement pipe and redo the waterproofing.
2. Intermittent not too serious The leakage has always been very stable When taking a bath or when there is other open water on the ground, the leakage of water This situation should be solvable There is one.
A product of invisible waterproof liquid (seam leakage buster) Simply brush twice on the tile surface and joints to block the floor drain, and keep fish in the bathroom for a long time There are no marks on the ground after brushing.
If you can't find it locally, you can go to TAOBAO WANG to find out that there are many treasures there.
-
Anonymous users2024-01-22Answer: First, close the toilet and then observe it carefully. If there are no obvious traces of leakage downstairs during the process of closing the water, it means that there is a problem with the water pipes. First, reconnect all the water pipes under the ground and seal them.
If the water level drops when the water is closed, and the leakage downstairs is serious, it means that the waterproof layer is a problem. Clean off the original waterproof layer first, seal the details with a waterproof strip, and then recoat the waterproof material.
Determine whether the cause of water leakage is a waterproof problem or a water pipe problem, first close the water in the bathroom, and then observe, when the water is closed, the water should be put three centimeters high, if there is no obvious leakage trace downstairs in the process of closing the water, it means that it is not a problem with the waterproof layer, or a problem with the water pipe; If the water level drops when the water is closed, and the leakage downstairs is serious, it means that the waterproof layer is a problem.
If the water pipe is leaking, then after the floor tiles are planed, you need to find the joints of the water pipes below, and then re-dock all these joints, and then seal them, and then bury the water pipes into the ground after treatment, and then use the plugging treasure or cement mortar to smooth out, repair the waterproofing and then restore the floor tiles, you can use it normally.
Question: If it's a water pipe leak, do you have to throw bricks?
Answer: Do you have to find where the water pipe is leaking, and then renovate it, or replace it with a new one?
Answer: First, close the toilet and then observe it carefully. If there are no obvious traces of leakage downstairs during the process of closing the water, it means that there is a problem with the water pipes. First, reconnect all the water pipes under the ground and seal them. >>>More
Generally, after brushing waterproofing, turn off the water test.
1.Toilet leakage maintenance causes and maintenance methods: 1) Toilet leakage causes: >>>More
In order to do the waterproofing in one step: (1) clean each pipe and the surrounding 10 cm radius; Rinsing with water works best, but wait until it has dried before proceeding to the next step. (2) Brush the waterproof powder several times to 1ยท5mm or do an additional layer of SBS, roll it up to plus or minus zero in the house, (3) and then do the waterproof as a whole.
It is possible that you use the coating film waterproofing, rather than the membrane waterproofing (polymer waterproof material), the coating film waterproofing has just been completed and the structural floor slab is integrated with the surface, and there is a protective film on the surface, when the time is long, the concrete structure floor slab may produce cracks, and then tear the coating film waterproof layer attached to the floor, thus leaking. It is recommended to do the waterproofing again, using polymer membrane, the effect is much better than the liquid waterproof material.