-
Anonymous users2024-01-23How many floors of your house, where do you want to go to the bathroom water, planing the ground on the first floor, no need to do beams, high-rise words to do light wall without beams, high-rise squatting to go into the water to do the bottom of the floor squatting can be directly put without padding, do your own house on the floor to have a water inlet, to the distance between the sewer pipes to a slope, so that it is almost 400 high, but also depends on where you go into the water, you had better find a sewer, first connect the pipe, pay attention to be sure to keep the inlet, Otherwise, it will be disgusting.
-
Anonymous users2024-01-22The height of the floor of the flushing toilet depends on whether the sewer pipe needs to be crossed on the original ground, and if the sewer pipe can be made downstairs, this does not need to be high.
-
Anonymous users2024-01-21The toilet is divided into wall row and floor row, and only needs to have a pipe to drain it. It has little to do with the actual height.
-
Anonymous users2024-01-20110 pipes are used for sewer pipes, and 110 pipes must be buried first·· That's at least 400 backfills.
Toilet flush valve is a common one in our family, but how to install, the flush valve used in the toilet in different places is different, now there are three kinds of toilet flush valves, induction, foot pedal, manual, and one is a toilet flush that uses a water tank, and the principle of their flush valve is different. So how to repair the toilet flush valve keeps coming out of the water? >>>More
The problem is complicated, involving water supply and drainage, moisture and water resistance, odor resistance, and so on. It is feasible to assume that all conditions are met. The cabinet can be partitioned with tempered glass, and the side with the wall must be completely shoveled out of the ash and sand, re-mixed with cement ash, and the wall must be moisture-proof. >>>More
You just have to switch the square iron to the other end and insert it again.
There is a difference in the water flow rate of the two buttons of the toilet bowl of larger brands such as Kohler and TOTO, but some domestic brands do not have much difference. The original design of the product is to save water, which is produced after drawing on the design of a water-saving toilet in foreign countries, hoping to provide different water flows according to the different needs of users. Therefore, the small button is designed for situations where the water consumption is relatively small.
Some of them are caused by the problem of water alkali, try to use some vinegar or the like, and first dissolve the alkali, which can be better.