-
Anonymous users2024-01-23There are several reasons for this.
1. The water level is not enough, the accessories are not installed properly, and the allocation is not good.
2. The sewer pipe itself is blocked by limbs and hands, or other problems.
3. The toilet siphon pipe is hungry and leaking, the toilet itself has a bad flushing function, and the punching is not standard.
Solution: 1. Find after-sales adjustment.
2. If the water pipe is blocked, dredge the pipe.
3. The quality is poor, and if there are rough conditions, replace it with a good quality.
-
Anonymous users2024-01-22What's blocked?! No!
There is a sealing ring at the interface between the toilet and the floor drain, if the ring is aged or other reasons are not good, the toilet will not be good. It's also simple to change this ring, that is, to remove the toilet bowl (isn't it generally that there are two screws on the side of the toilet, unscrew the screws, and lift it up), buy the toilet seal from the home improvement and building materials market, and replace it on OK. Then apply glass glue to waterproof.
The reason why it can't be pumped is that the seal is not done well, and there is air leakage from there, do you think about it, can there still be pressure?! Let's change it. It was also replaced with a lot of water and effort.
-
Anonymous users2024-01-21Pour a decomposing unclog into the toilet bowl and let it dissolve the clogged sewer pipe to unclog the pipe.
2.Replace the mat at the bottom of the toilet to block the air, and the suction power will naturally be greater if the air does not leak in.
3.The accessories in the toilet tank are misplaced, so the water in the tank does not reach the water level, and the suction power will be small, so it can be installed correctly.
Give a thumbs up for your hard work
1) If the amount of water under the fruit is insufficient, you can open the lid of the water tank to adjust the amount of water. (2) There are two plastic rods under the toilet water button, and there are cocks on them to adjust the length of the plastic rods to control the amount of water. (3) If it still doesn't work, you can only change the toilet, you can choose a siphon toilet, the effect is good. >>>More
There are several reasons for this:
1. The water level is not enough, the accessories are not installed properly, and the allocation is not good. >>>More
If there is no suction in the flush, it means that something has been blocked and needs to be pumped through with a wire.
You can only use the leather puff to suck, or use a professional dredging spring to dredge, I believe you don't have this thing, if the blockage is not bad, use the leather puff, if it is powerful, find a professional dredge phone in the corridor, call someone to help you, and the ultimate way, is to remove the toilet and then pass, is more troublesome.
Does anyone know? Let's find a few reasons to see what went wrong. Causes of a leaky flush toilet: >>>More