-
Anonymous users2024-01-23Don't you see a drop of water?
There are many reasons for dripping:
The sealing ring in the joint is aged and can be replaced;
The rubber tube inside the snakeskin tube is cracked and can be cut short or replaced;
The inner sealing ring of the faucet is aging, and it can be disassembled and repaired or the entire faucet can be replaced;
The above inspection and repair are easy first and then difficult.
— Peace be upon you.
-
Anonymous users2024-01-22If it is determined that the pipe is leaking, check it first as mentioned upstairs to see if the gasket is aging, or the steel tight solid at the head of the pipe body is broken, and then deal with it. The inner gasket can be replaced, if the outer steel is tight and solid aging and cracked, it is necessary to replace the pipe. At the same time, you can check whether the valve body is aging and leaking, and replace it together.
See if the landlord is a single pipe, is it a cold water pipe?
-
Anonymous users2024-01-21Hello friend, it should be a leak in the water pipe joint, you can unscrew the joint to see if the position of the joint is not tightly closed. If that's not the case, consider changing the fitting. Hope it helps.
-
Anonymous users2024-01-20This is a leakage of the angle valve, which is generally not tightened.
It is necessary to determine the cause of the dripping, if it is a water leak upstairs, contact the residents upstairs to make waterproof paint for the bathroom, if it is the condensation formed by steam when you take a bath in the bathroom, it is a normal phenomenon.
This situation can only be radically cured by knocking the tiles around the pipe, cleaning up the pipe with the filler that was decorated before the decoration, and then brushing the waterproof glue, paying attention to the glue when the pipe must be painted 3-5 cm above the ground, and then backfilling with concrete to level and solidify the tiles with fine mortar cement, it is OK, although it is a little troublesome but reliable and reliable, I hope it can help you.
It should be condensate to keep warm, and it is recommended to check if there is any leakage.
Clean up the dirt inside, buy a little plugging spirit (waterproof materials are available for sale), and plug it.
Find the merchant who installed the ceiling at that time to dismantle it and assist in the inspection! Make an appointment to call both the ceiling worker and the water heater worker to check it out at the same time! The ceiling worker should give a 50 yuan service fee, which should be about the same.