-
Anonymous users2024-01-23If the ceiling lamp is turned off and measured with a pen, there should be two reasons: one is that the switch control back is the zero line, there is no answer to control the live wire, the shutdown is the zero line, the live wire is still there, if so, it is dangerous, it should be adjusted, and the switch controls the live wire; Another reason is that there is a rectifier source or a segmented controller in some lamps, where there is an electrolytic capacitor, just after the switch is turned off, the electricity on the capacitor has not been discharged, so it can be measured, if so, wait until a long time, this voltage is gone.
-
Anonymous users2024-01-22This is because there is a mistake in the wiring of your house, and the live wire is not connected to the switch. The switch is closed on the neutral line, so this phenomenon occurs.
Do you mean to say... Just turn on the light is not particularly bright. After a while. >>>More
The larger button has a greater water discharge pressure and is used to flush the stool; The smaller button has less pressure to discharge water and is used to flush urine. >>>More
How could there not be? The better ones have two living rooms in a two-story complex, the high-end villas have more than two living rooms, and the general villas have only one living room.
Smith's good, I've been using it for 5 years.
There is no impact, whether you are an integrated ceiling or a plastic ceiling, at most a small hole is drilled in the place where the lamp is installed, and the small hole is just covered by the lamp, whether it is a round lamp square lamp has no effect.