-
Anonymous users2024-01-23It cannot be reinforced, only dismantled and re-paved, which is a serious construction quality problem, for which the construction party should be responsible.
In addition, it is recommended that in order to prevent the potential safety hazards caused by falling tiles before re-paving, it is recommended to wrap them tightly with scotch tape, and then find workers to re-apply as soon as possible.
-
Anonymous users2024-01-22If the loose area of the hollow drum is relatively small and the situation is not serious, it is recommended to repair it with tile adhesive according to the following method:
1.First, clean the cement where the tiles fall off to expose the cement base.
2.Pour the porcelain sticker powder into water and stir it into a paste (the mixing ratio is: 20kg powder and 6kg water), and after stirring, it needs to stand still for about 10 minutes, and then stir slightly before use, which helps to increase the adhesion force.
3.Use porcelain tile adhesive to repair and level the peeling cement base first, and then evenly apply the tile adhesive to the back of the tile.
4.Knead the tiles to the point where they originally fell off.
5.Finally, gently tap the tile with a rubber hammer so that it is the same height as the other tiles.
However, if the area of the hollow drum is loose, in order to completely solve the problem of hollow drum, it is recommended to use tile adhesive to re-pave it all.
-
Anonymous users2024-01-21It can be repaired with non-marking reinforcement.
I thought that wallpaper in the living room was not the best choice, and it would come off after a long time, so it was better to paint the wall!!
The walls are tiled, which was more fashionable in the mid-80s, and now they are all cement painted walls. Be sure to stick it, only, stick half of the wall 1 meter. But it's better not to post it. If you think about the house built in 2013, with the decoration method of 30 years ago, is it very old-fashioned and a pity.
1. The anti-slip property of ceramic tiles.
Bathroom tiles must be made of non-slip texture. When we go to buy this, the merchant will generally prompt us, and the most recommended is matte or shallow convex and concave floor tiles, the reason is very simple: non-slip. >>>More
Whether it is the first to paste the floor tiles or the first wall tiles are OK, the first to pave the floor tiles or the first to lay the wall tiles, need to be decided according to the specific situation of the resident's home decoration, mainly to paste the floor tiles or wall tiles to carry out reasonable protection of the construction project, paste the wall tiles need to pay attention to the level and right angle between each tile must be done. When the floor tiles are laid, they should be subsidized in a parallel way on the side of the wall, and the brick joints should be aligned and no joints should be left.
Of course, you can, mainly according to the home decoration style and personal preferences. The wallpaper is more warm. But now in order to save costs, there are also ordinary home decoration that are only pasted on one wall, as long as they are well matched, they will also look good. I hope my answer can help you, and I hope to adopt it!