How to deal with the leakage in the bathroom, which master will answer?

Hello, I'm fixing a leak in the bathroom. You can check whether the water is dripping in the places with raw tape such as water valves, faucets, etc., if it does not drip water, find a plumber to test the pressure with a pressure press, to see if the pipes are not connected, and the floor heating should also be tested for pressure, I hope it will help you, if the pressure test is no problem, the neighbor said that it is a lot of water tests, but it has been used for a lot of five years, and the waterproof layer is aging and leaking, if there are still questions, you can ask me.

The waterproof sealing effect of the bathroom floor slab is relatively good, and the key to dealing with the problem of water leakage is to accurately find out the leakage point. The leakage point mostly occurs in the upper and lower water pipes, the junction of the floor drain and the floor slab, clean it up after finding the leakage point (the cleaning range is larger than the leakage range) and make it dry, and seal it with sealant. It is better to work from the floor slab, or from the roof if it is not convenient. >>>More

First of all, it is necessary to judge the cause of water leakage in the bathroom, and judge the method of water seepage on the ground. The method of judging the leakage of the water pipe, if the bathroom does not use the hand for several days but there is still a leakage is the problem of the water pipe, the toilet leakage repair is a big problem, in the case of the water pipe is not broken, the dust, oil, water and so on on on the surface can be cleaned to maintain the dryness of the ground, such as the tile joint is filled with caulk, you need to use a knife to draw a small groove, the tile joint, wall joint and other parts are sprayed with penetrating waterproofing agent, to spray evenly, Wait until it's almost dry and fill in the defects with caulk. >>>More

I think most of the bathroom leakage is caused by the wall waterproofing during the decoration, and the solution to the problem of water leakage, I briefly introduced a few points, I hope you adopt. 1. Protect the wall and ground, and first smash the tiles of the wall and the ground at the junction of the wall and the ground according to the leakage point downstairs (that is, the wall of the lowest layer of the wall and a circle of floor tiles connected to the wall). 2. Clean up the loose floating soil mortar from the base layer of the smashed tiles, and paint the interface agent on the surface; 3. After the interface agent is dried, paint the plugging spirit to make it seamless and covered with the original wall and ground waterproofing; 4. After the paint film of the leakage plugging spirit or other waterproof materials is dry, do the ground closed water test for 24 hours, and then pave the wall and floor tiles after there is no leakage.

To solve this problem, we should mainly do a good job of waterproofing to prevent the occurrence of leakage incidents.