-
Hello you this does not break the tile is not solved, you want how much pressure the water has, the outside can not be blocked. And it's not a piece, because it has to be cut from the borehole leakage, and then stretch out the hot melter to heat and melt, and the two ends have no room for movement and can't be used!
-
Glue a piece of water pipe with the same size as the one you knocked down, and then reinforce it with something else.
-
Because the water supply pipe has water pressure, there is no direct way to repair the intact, generally PPR hot melt pipe, you can only remove the tiles, add pipe hoops and weld them from scratch.
-
I've also had this situation, and there's no way but to knock it out! I've tried a lot of things!
-
1 dozen porcelain. , 2 off the water (valve).
-
Whether it's a drain or a water pipe.
It should be pressure-tested to see if there is a leak.
The equipotential box is set up to connect the lightning protection down wire of the roof, which is connected to the lightning rod of the roof at the upper end and the lightning protection down wire of the house foundation at the lower end. >>>More
Try making a hook with one end of the wire, and you should be able to hook the lid up.
Cut off the broken tube and make a joint, which is sealed with glue. >>>More
If it is just poured in, it can be waterproof and flushed, there should be no problem, because all the places connected to the sewer have an S bend, and there is water storage in it, which is used to prevent odors, and it should be no problem to rinse more. Courtesy of Migo.com.