-
Anonymous users2024-01-23There are screws in the water tank on the water, and there is a kind of iron that is a friend of the lead iron, and the iron piece in the middle of the iron is pulled upwards to be lowered, and the downward is high, you open the upper lid of the toilet, you can see the ball wheel inside to change the connecting rod mechanism. There is a screw on top of which you can see that there is a judgment screw to adjust it up, and you can meet your requirements. Hope it can help you, hopefully.
-
Anonymous users2024-01-222. Remove the water inlet and find the regulating valve that adjusts the water level inside.
3. Rotate the gear clockwise, you can make the water level rise, but the design of each brand is different, some are dialed up and down, if it is this kind of flush toilet, if you want to increase the flushing strength, you have to dial down, and lowering the water level is up.
Dial. 4. There is also a white cylinder in the water tank of some flush toilets, there will be different units on the cylinder, and the two blue gears can be adjusted to the size of the gear, and the upward adjustment is to raise the water level.
-
Anonymous users2024-01-21How to adjust the toilet water level if it is too high, don't be afraid, I'll teach you.
-
Anonymous users2024-01-20Whether it is more or less water inlet or less water outflow.
First of all, we lift the lid of the toilet, pay attention to be sure to hold it steady, handle it gently, and do not bump it. >>>More
There are screws in the water tank on the water, and there is an iron that pinched the iron in the middle of the iron and pulled the iron upwards to adjust the low, down is high, open the upper lid of the toilet, you can see the ball linkage mechanism inside. >>>More
There are two places in it that can be adjusted, there is one inlet rod, and there is also one flush valve, I don't know what kind of accessories your toilet is equipped with, I don't know the specific, but the toilet accessories are basically the same adjustable,
Open the toilet water phase cover, which is similar to the pole of the fast son, and there is a cross on it, and you can adjust the water level of the water phase by turning it left and right with a cross tape knife.
The model of the water valve is different, the way of adjustment is also different, the float has a steel wire rod below the float and there is a metal shrapnel on the top, and the metal sheet can be adjusted by moving the metal piece up and down by hand to the pincher together, and there is an obvious screw rod at the top of the water valve. Adjust the height of the pontoon by adjusting the screw rod (forward rotation, reverse rotation), try it