There are a lot of network cable interfaces on the wall at home, and the interface in the living roo

Updated on Living room 2024-04-13
1 answers
  1. Anonymous users2024-01-23

    It depends on how the network was designed when you renovated it, and whether there was acceptance after the renovation was completed. It could be a problem with the network structure, or it could be a wiring problem.

Related questions
The network cable interface on the wall of the bedroom at home can't be used in the living room, wha
7 answers2024-04-13

Are you sure that the line is connected when you decorate, and where is the line connected, it doesn't work, you have to have these tools, line finder, line tester, network cable pliers, crystal head, why is it so troublesome for you to get, because sometimes this can be used! It is recommended to repair, sometimes the line is not done well when decorating, this is simple, remove the wall box to see the line sequence is wrong, take a slotted screwdriver directly to the card on the line, if you don't know anything and don't want to get it, just pull a bright line over the line.

How to connect the wireless router to the network cable interface in the bedroom and living room at
2 answers2024-04-13

It may be that the fixed IP settings of your 2 routers are conflicting. >>>More

There is only a plugged in network cable in the living room at home, and I want to put the computer
3 answers2024-04-13

No, you can't

Either use a wireless router, but the signal may not be good in the bedroom; Either just connect the network cable and come out, it may be ugly. >>>More

There is a network cable interface in the study at home, and the wireless signal of the router in th
2 answers2024-04-13

Buy a wireless router again, connect it to the living room with a network cable, change the IP address of the newly bought router, and ask the merchant to change it for you when you buy it.

There are two network cable interfaces in the house, one in the living room and one in the study
3 answers2024-04-13

Use the network cable on the cat to connect to the WAN port of the router first, and then connect a cable from the LAN port of the router to connect with the network cable of your living room and study. (The entry routing address and password will generally be on the bottom of the router on the sticker).