After the water heater is turned on, the washbasin does not come with cold water, there is hot water

You should double-check that the hot water pipes in your home are connected to the washbasin and kitchen faucet, and then see if the triangular valves under the two basins are open. The lack of hot water in general is these two reasons.

It may be that there is air returning from the water pipe, you turn off the inlet faucet of the water heater, and then turn on all the hot water faucets connected to the water heater to release water, after putting it out, turn off the hot water faucet first, then turn on the inlet faucet of the water heater, and then open the flower to sprinkle hot water. (Turn the hot water directly to the maximum, and do not mix the cold water with water to adjust the water temperature). >>>More

This should be the shower mixing faucet inlet filter screen has impurities blocked, close the main valve to remove the mixing faucet and clean the filter screen, when disassembled, cold water pipe, hot water pipe two som to rotate the same number of turns at the same time, that is, after turning the cold water, turn the hot water, it is easy to operate, try it, you can not repair it can find the property department to repair.

The hot water should be smaller, this may be the installation is reversed, you screw the bathroom to the side of the water is smaller, and wait for five minutes to have hot water.

Of course, the water heater has two water outlets, and the left hot water outlet is to supply all hot water needs, such as kitchen sinks, bathroom showers and basins, which is very convenient!