The toilet keeps going up and down on its own

Updated on Toilet 2024-04-28
5 answers
  1. Anonymous users2024-01-23

    This means that the water float or water float connecting rod of the toilet is broken, and only one set needs to be replaced.

  2. Anonymous users2024-01-22

    Ball under the lever in the tank: 1 not in the right 2 in age.

  3. Anonymous users2024-01-21

    Hello, you can first check whether the flush switch has an instant rebound, if not, there will be a phenomenon of flowing water all the time.

    Because it will wear out after being used for too long, it will be stuck, and it cannot be reset, and the switch can be reset by repeating it several times.

    2. The limiting device of the water level is also very critical, if the area is too loose or set too high, it will cause the water level to exceed the overflow level, which will flow into the toilet bowl and the phenomenon of more than the water flow.

    3. If there is no problem with the above two, then you should check whether the sealant at the outlet of the box is damaged or plugged by foreign objects.

    It is also possible that the equipment is aging.

    It's okay to ask questions.

    If none of the above is true, it could be a sewer problem.

    Question: The water keeps going up, exceeding the drain and overflowing.

    You can find a professional to repair it, and the cost of this repair is not particularly expensive.

  4. Anonymous users2024-01-20

    Press the flush switch to the end, stop for 10 seconds, then let go, give it a try.

  5. Anonymous users2024-01-19

    The control water inside is broken, just buy one and replace it.

Related questions
2 answers2024-04-28

"The cat keeps going to the toilet and barks in the toilet", this is already abnormal, it is a manifestation of urgency, frequent urination, and painful urination, that is, the cat can't speak, or it will shout "I'm uncomfortable, hurry up and go to the hospital!" "Hurry up to the hospital, otherwise the delay will cause kidney disease."

2 answers2024-04-28

If the water level control part is broken, you can open the lid to check it and repair it. For the time being, you can turn off the valve of the inlet pipe and open the valve after repair.

5 answers2024-04-28

Turn off the inlet valve of the toilet first, and then find someone to fix it.

11 answers2024-04-28

The toilet in the bathroom is closely related to our lives, but after the toilet has been used for a long time, it is inevitable that there will be some problems, such as: no water, leakage, blockage, non-stop water, etc., so how to repair the toilet bowl without water? Let's learn together. >>>More

5 answers2024-04-28

The reason could be: the flushing valve on the toilet is broken or stuck. >>>More