The bathroom is slotted on the ground and has been smeared with cement, how to do waterproofing

Updated on Bathroom 2024-04-03
2 answers
  1. Anonymous users2024-01-23

    After the installation of the hydropower line, the pipe groove is carefully sealed with cement mortar, and then leveled to do waterproofing normally.

    Bathroom waterproofing, common waterproof materials include mortar waterproofing agent, waterproof coating and waterproof membrane.

    Because the kitchen and bathroom itself is a relatively stable part of the house structure, coupled with a small area and many pipes, if the waterproof membrane is used, it is not only not easy to cut and paste, but also has high technical requirements for construction workers, so it is now widely used waterproof coating and mortar waterproofing agent.

    More than 80% of the water leakage between the kitchen and bathroom is concentrated in the yin and yang corners, pipes, sanitary ware, and other places, so it is recommended to use kitchen and bathroom waterproof slurry when doing waterproofing.

  2. Anonymous users2024-01-22

    The possibility of cracking in the water pipe is relatively small, but the possibility of leakage at the joint of the water pipe is high. If the bathroom floor is slotted and piped, it is best to waterproof the slotted place before laying the pipe, and then seal the pipe.

Related questions
2 answers2024-04-03

I didn't quite understand what you were talking about, so I had to guess. One is a portable speaker, which can be placed somewhere, you can insert an SD card, U disk, etc., and the sound quality is average; There is also a background music host, embedded in the wall, which can insert SD cards and USB flash drives, but it needs to be connected to ceiling speakers. Sound quality depends on the quality of the product. >>>More

4 answers2024-04-03

First of all, you must determine whether you use PVC pipes or PPR pipes, PVC is glued together PPR is melted with a hot melter, now generally do not use PVC pipes, all use PPR, PVC should be filled with sand, because the pipe is easy to damage, that is, the pipe should be covered with sand. PPR is much better, after waterproofing, the pipe is done and filled to the cement and tiles. After the toilet drainage is done, the waterproofing is done, and the water supply is done. >>>More

1 answers2024-04-03

This is because the waterproof of the bathroom is not caused by water leakage after changing the water and electricity, the water leakage in the living room is basically the water leakage from the bathroom, and the root cause is the leakage of the bathroom. The floor should be waterproof more than 200mm from the wall to the wall, and all around the bathroom.

9 answers2024-04-03

The place where the groove has been opened is waterproofed on one side, and the waterproof should cover the original waterproof for more than 10 cm, and then bury the thread in the groove.

8 answers2024-04-03

There are three steps:

1. Pick it up, 2. Walk over--- of course, to the garbage basket, 3. Throw it in. >>>More