The kitchen faucet has a small cold water output, and there is a big shortage of hot water output

Start by checking the cold water hose under the faucet.

The opening and closing range of the DU angle valve (assuming that there is no water leakage), followed by the extension of the pipeline.

Check ahead to see if there are any other valves that are not well controlled. If they have been opened to the maximum, then there may be a blockage of the cold water pipeline and the pipeline in front of it, and the reason for the blockage may be that the time of the hot melt connection of the pipeline is not done well, and the time is too long, resulting in the inner diameter of the pipe becoming smaller.

The basin is cold underneath.

BAI water hose in the middle of the two ends of the interface.

Du clogging, resulting in small or no water, dao I have encountered and repaired the version once, put the rubber ring inside the filter right.

Remove the net and clean, if there is a foreign object or become smaller in the nozzle at the other end, use the cross knife to put it in the mouth and turn it a few times to make the nozzle unblocked, so that after treatment, reconnect the interface and check whether there is any leakage, and the cold water is normal after boiling water. The method of repairing hot water pipes is the same as that of repairing cold water pipes.

The kitchen faucet has a small cold water outlet, and there is a big shortage of hot water outlet, what's going on, and how to maintain it yourself?

Dear, hello, I'm glad to answer the kitchen faucet cold water is small, and the hot water is very short, what's going on, how to repair yourself? Gao Tong replied that the following are the reasons and solutions for the large flow of hot water pipes and small cold water: 1. Check whether the water output of other faucets is normal, and if the water output is small, explain that the water pressure is small.

Treatment: Check whether the main valve of the water inlet is fully opened, and whether the water pressure of the pipeline is lacking. 2. Disassemble the mixing valve, that is, the triple valve (generally speaking, the simple shower should be dismantled and inspected first), and check whether the universal wire is blocked by the raw material belt, if there is no water output or small, it may be that the water pipe welding is not good.

The water heater in the old house suddenly has a small question about the cold water, which is generally a problem with the mixing valve.

The kitchen faucet has a small cold water outlet, and there is a big shortage of hot water outlet, what's going on, and how to maintain it yourself?

The kitchen faucet has a small cold water output, and there is a big shortage of hot water output, what is going on, how can you maintain your own potato repair? Hello dear, it is very likely that the angle valve or valve is not fully opened, at this time you need to turn off the valve, and unscrew the faucet, to see if there is any impurities blocked, and then to see if the valve is opened to the maximum. There is also the unstable water pressure, so the best solution for this is to install a booster pump.

In addition, it may also be that the nozzle is blocked, and the hose needs to be removed and seen if the hose is aging. I hope my answer is helpful to you, and finally I wish you good health and a happy mood again! <>