What is the problem of the toilet draining slowly after 4 years of use

Updated on Toilet 2024-03-29
4 answers
  1. Anonymous users2024-01-23

    This situation must be caused by a clogged pipe. Due to the blockage of the pipes, the water in the toilet does not go down, so it will accumulate under the toilet. And there is also a problem with the installation, it should be said that even if the toilet is clogged, the water will not come out from the side, because the toilet bowl and the sewer pipe mouth are sealed.

    This situation illustrates the toilet bowl with the drain pipe.

  2. Anonymous users2024-01-22

    If there is limescale, find a way to clean it.

  3. Anonymous users2024-01-21

    It may be blocked, dredged ha.

  4. Anonymous users2024-01-20

    It's time to get the sewer, and if it's not good, change it.

Related questions
5 answers2024-03-29

It's not the toilet that is the fault, it's the septic tank that's full, and the land where I rented a house also appeared, and the landlord was asked to get it done. It may be blocked, the detection method is to take a basin of water and flush it directly, so that it is not blocked, otherwise it is blocked. 2. If it's not blocked, it's the toilet itself. >>>More

10 answers2024-03-29

The problem with the toilet bowl having a loud sound may be that the water supply valve is loose, that is, it has been discharging water, and every time after using the toilet, you should press the switch on the toilet lid twice to lift it up.

5 answers2024-03-29

How to deal with the toilet bowl water inlet non-stop:

1. Whether the black semi-circular float on the overboard assembly is properly covered, or the black semi-circular float falls off, and the rope is still stuck. >>>More

10 answers2024-03-29

In this case, you can see if there is a trap in the pipe. Because the toilet itself has a trap, there is air pressure in the middle of the two traps, so it will not be able to get into the water. If this happens, we can open the vent at the back of the toilet. >>>More

1 answers2024-03-29

1. Check whether the water level in the bucket reaches the elevation, if the water level is low, then adjust the height of the float, 2Check whether the drain is blocked or half-blocked, and whether the outlet around the toilet is blocked.