-
Chandelier has a short circuit or leakage, please check it with an electrician.
-
It is the ground wire that should be connected to the zero wire at one end of the switch, and the closing will protect the action!
-
Most likely because the zero line is grounded, if the zero line in your home distribution box has not been protected by leakage, or the air opening of 1P+N is used, then this situation is likely to occur, it is recommended that the zero line should also go through the leakage protection switch, and you also need to check whether there is a problem with the wire of this circuit.
-
Check the joints of the lamp line, remove the lamp head, and check whether the lamp port is short-circuited. That's basically where the problem goes!
Is it the wire used in the decoration? If so, it is too thin, and the starting current of the lamp is large and causes tripping. >>>More
Wear rubber gloves or close the main gate for treatment. It should be a poor contact, and it is best to find an electrician with experience to deal with it.
It may be that the heating leak in the upper floor has seeped into the wall below you, you can first find out the property research to find out the situation and find out the leak point. Find a solution.
There are many wealth positions in the family, and the living room represents the fortune of the male owner, so it is generally based on the living room.
This shows that the smoke absorption effect of the range hood is not good, and there is a problem of smoke leakage. >>>More