Hello, carpenter brother, I want to ask for advice on PVC ceiling, how to make that wooden keel fram

WITH 2 TIMES 4 WOODEN SQUARES, THE AUXILIARY KEEL IS FIXED AT INTERVALS OF 30-40CM, AND THEN A MAIN KEEL IS ABOUT 100CM ON THE BACK OF THE SECONDARY KEEL

Now the surface pops up the line, nails it with cement, and cuts off the size before it can be operated.

First of all, it is necessary to lay a good horizontal line, and determine the pay-off position of the ceiling according to the horizontal line.

Use a percussion drill to drill holes, cut into the mallet, and then nail back.

The sub fastens the strips around the wall - this is the keel along the edge;

Depending on the length of the room, the position of the transverse keel is evenly distributed, generally with a spacing of 80 100 cm (a little more, of course, is better); Measure the size of both sides, and nail the rungs to the keel along the edge with nails according to this size.

If the top of the runghead keel needs to be suspended, you can drill holes and fix the wooden strips on the roof surface, and the direction should be crossed with the rungs keel, and then nail the wooden strips up and down on this wooden strip to connect with the rungs keel below. Starting from 30 cm from the wall, the spacing of the middle part can be evenly distributed, and the spacing is about 80 cm; Before doing this step, it is necessary to pull a construction line at both ends to determine the horizontal height of the rungs keels and ensure that all the rungs keels are on a horizontal plane.

If electrical equipment such as lamps and lanterns need to be installed on the roof, the number of rungs keel can be increased according to the situation to play a role in reinforcement. After this is done, you can install the corner strips of the PVC gusset. This is best fixed with screws.

My home is an integrated ceiling copy 15 flat, if you do PVC, bai has to spend 1300, and du does integration cost 2100, but the integration is very beautiful.

And I heard that PVC is often damp and easy to peel.

The craftsman first set aside a position from the item down (the height of the bathroom bomb is installed in the bathroom, and the lights should be installed in other places, and the height should be determined according to the thickness of the object); Pop up a horizontal line (the level of the line bullet, the flat of the top hanging); PVC is nailed with cement to the wooden strips, the integrated ceiling is coated with white latex on the wall, and the buckle is coated with a stick; Finally, in the circle, apply glass glue to seal.