How to prevent the toilet from splashing

Updated on Toilet 2024-03-01
12 answers
  1. Anonymous users2024-01-23

    Teach you how to prevent spilling water when using the toilet.

  2. Anonymous users2024-01-22

    Using the toilet splash proof foam artifact, splash proof and odor prevention effect with foam is the best. At the same time, the toilet is not easy to stick, not easy to get dirty, yes, reduce frequent brushing of the toilet. This is the trend of toilet development in the future, and all toilets should be equipped with this function in the future.

    You can also get a toilet bowl to clean the house. When you go to the toilet, you can't see it, you can't smell it, and you go to the toilet with a fragrance. After use, the effect is quite satisfactory.

    Splashing water has always been a problem for us.

    When I went to the toilet, I had a dry and smooth buttocks, and a torpedo plopped down, splashing half a story high, and slamming it on my ass, and I wanted to cry at that time! It's okay, if this toilet bowl has a freshly dissolved feces water mixture, then don't live!

    Dirty! But what can be done?

    If there is less water, it is easy to smell and sticky stools.

    If there is more water, our troubles will appear, splashing water!

    How to prevent splashing, try to lower your butt when pulling, quickly lift the PP when the poop falls, and so on. Such as dive bombers. , similar to the first move, after pulling out the poop, stand up as fast as possible. You can use the sphincter to cut the poop evenly into small pieces, and the smaller the splash, the less the splash will not be too high. to control your muscles so that the poop is in full strips so that you don't make a splash when you slide it down the toilet. , catch the poop that fell and gently place it in the toilet. and put some ice cubes in the toilet. , sitting in the toilet water. , facing the water tank position, so that the poop does not fall into the water, but falls on the dry place. Put a paper towel on the surface of the toilet water and catch the poop. If the paper towel is captured by the first wave of poop, another one needs to be placed.

    You can also put multiple sheets at a time, so that the paper towel has a relatively good bearing capacity. Above.

  3. Anonymous users2024-01-21

    Is the toilet bowl spilling annoying? Teach you a few tricks to solve the problem easily, try it quickly.

  4. Anonymous users2024-01-20

    You can try pulling out the water supply pipe in the tank, so that after each flush, the water seal area will be reduced, and the splashing will be reduced. If it doesn't affect the flush, this should be a good idea.

  5. Anonymous users2024-01-19

    That's right, replace it with a Koch foam toilet to ensure that it doesn't splash It still smells, my foam toilet has been used for half a year, and it's very good.

  6. Anonymous users2024-01-18

    The fundamental solution is to replace it with a non-splashing, smelly, healthy and bacteriostatic Koch smart foam toilet.

  7. Anonymous users2024-01-17

    Toilet splash mat (Taobao).

  8. Anonymous users2024-01-16

    Mr. Wenzhou Lin invented a new type of practical toilet splash preventer, which has been applied for a patent and in the process of physical construction, this product is easy to install, and the effect is far beyond the existing splash prevention products! Let your fart never be troubled when you poop on the toilet again! Stay tuned!

  9. Anonymous users2024-01-15

    I have a better way, but only for household toilets. Before the tuba, use a basin to catch a basin of water, and quickly pour it all into the toilet bowl at once, the water in the toilet bowl will flow very clean under the pressure and siphon action, and the water level will drop very low, so that there will be no splashing. Other methods, such as padding, can also alleviate the problem to a certain extent, but none of them are as effective as the one I said.

  10. Anonymous users2024-01-14

    There is a toilet splash-proof product, its idea is to install a hollow rubber airbag at the bottom of the toilet cushion, place a special balloon on the inner wall of the toilet, this balloon will not burst with a needle, and then use the trachea to connect the balloon with the airbag, when you defecate, you must put the toilet cushion down, and then sit on it, when you sit down, the airbag is under pressure, and the air inside flows to the balloon, so that the balloon is inflated, and the stool falls directly on the balloon, not directly in the water, In this way, there will be no splashes on the buttocks, when the rubber airbag is not under pressure, the air in the balloon will automatically flow back to the airbag, and it will not clog the toilet when flushing.

  11. Anonymous users2024-01-13

    1. The cause of toilet splashing.

    Toilet splashing is an unavoidable phenomenon in the design of almost all toilets, and the reason for this is related to the toilet trap. The toilet trap has two main functions: one is to reduce the adhesion of dirt to the inner wall of the toilet, and the other is to block the harmful gases from the sewer from entering the room through the toilet drain.

    In order to achieve a unified standard for these two functions, the national sanitary ceramics standard stipulates that the height of the water seal in the water trap must be greater than 50mm, and the water seal area must be greater than 85mm and 100mm. When the poop falls, it will inevitably provoke a rebound on the water surface of the toilet, and splashing is inevitable, but the splash is different.

    Second, the solution to the toilet splash.

    Solution 1 (Designer): Some designers raise the height of the water seal.

    Solution 2 (Users): For toilets that have no choice, in order to reduce the impact of poop on the water surface, most users choose to use toilet paper to spread on the water surface.

    Solution 3 (creativity): Install a set of equipment in a specially designed toilet, press the switch before using the toilet, and the toilet water seal will be immediately covered with a layer of snow-white foam.

    3. The special design of the splash-proof foam toilet.

    Can all toilets be fitted with a foam device and then equipped with this splash resistance? Unfortunately, this is not the case, because ordinary toilets cannot flush foam out, and the flush pipe has been redesigned specifically to flush foam, which can flush used foam with very light density out of the sewage pipe at one time. So it's a little shame – it would be nice if all the toilets at home could be fitted with this kind of foam device.

  12. Anonymous users2024-01-12

    Replace it with a Koch foam toilet and you're all set.

Related questions
2 answers2024-03-01

Put a few layers of paper in the water before use!

2 answers2024-03-01

You can try using a toilet splash proof.

Small and beautiful on the inner wall of the toilet, place more than 85% of the splash water, the price is 39 yuan. >>>More

1 answers2024-03-01

Toilet overflow prevention installation method 1: according to the different types of toilets. >>>More

7 answers2024-03-01

1. The cause of toilet splashing.

Toilet splashing is an unavoidable phenomenon in the design of almost all toilets, and the reason for this is related to the toilet trap. The toilet trap has two main functions: one is to reduce the adhesion of dirt to the inner wall of the toilet, and the other is to block the harmful gases from the sewer from entering the room through the toilet drain. >>>More

4 answers2024-03-01

You can use sugar water bottles to catch cockroaches, use 1-2 canned bottles, put 3 spoons of sugar water, add half a bowl of boiling water to flush into bait, put the bottle in the place where the cockroaches are active, and after the cockroaches smell the sweetness, they will climb to the canned 'trap'. >>>More