How to change the floor drain in the bathroom?

The joints between the old floor drain panel and the tile are separated by a screwdriver or other tools, and the cement around the floor pie is raised with a screw, and then the floor drain is struck with a small hammer to separate it from the cement; Use a groove to clean the cement layer around the old floor drain pit, pay attention to the drainage pipe needs to be temporarily plugged, and use Yinxian Tan to prevent debris from falling into the drainage pipe, resulting in the blockage of the drainage pipe.

If it is a bathroom, the previous general type of floor drain for an ordinary one, the replacement is actually relatively simple, as long as the original floor drain next to the fixed cement to him to pry loose, and then slowly pry out the head cover to pry out, but if it is an ordinary floor drain replaced by a submarine floor drain, then it is necessary to knock on the cement of the sewer outlet, and then the position of the sewer pipe is cleared out, so that the air hole of the submarine floor drain can be compared to the sewer that can be contacted, firmlyIn general, it is relatively simple to change the floor drain equipment, because he does not have a private buckle interface, or other docking interfaces.

Changing the floor drain in the bathroom involves waterproofing problems, and it is best to find a professional to replace it.

How to change the floor drain in the bathroom, many people don't know how to install the wrong one, come and take a look.

Bathroom floor drain replacement method, pick up the sub and pliers to completely take out the original floor drain, and remove the surrounding cement, clean up sand, cement and other debris, put the filter shaft dipped in water into the floor drain base, and properly rotate to make the silica gel around the filter shaft fully combined with the base, and put the filter screen to replace it.

Before replacing, it is necessary to select the specifications of the floor drain, so as to ensure the smooth installation, at present, the more common ones are 10*10cm square floor drain and 12cm round floor drain, this floor drain can choose the corresponding size according to the actual needs. Use a screwdriver or other tools to separate the damaged and old floor drain from the floor tiles, and then use a slotted screw to bring out the cement around it, if the old floor drain is attached to tiles, you can use a hammer to separate the cement from it, and then use a groove to clean the surrounding cement.

1. First of all, you should prepare a special cutting machine, use the cutting machine to cut off the old floor drain tiles, and then remove the original floor drain.

2. When cutting, sprinkle some water on the tile first, so that it can be cut into a straight line, otherwise it will be ugly if it is crooked.

3. After cutting, you can gently tap the surroundings with a hammer. After knocking it loose, you can slowly take out the old floor drain.

4. When the floor drain is taken out, the debris inside will emit bursts of peculiar smell, and the debris inside should be removed in time.

5. After the debris is removed, the drain should be plugged first to avoid the blockage of debris and garbage during the installation process.

6. Then use an awl to knock off the cement next to it.

7. Smash out a depression that can fit the floor drain, and then clean up the sediment inside.